4bangerjp.com
General Forums => The Mess Hall => Topic started by: wrangler387 on November 13, 2006, 09:14:59 PM
-
Well the rear most exhaust stud on my 2.5L broke inside the head... so i guess i'm going to be rebuilding my spare head instead of pulling off my current head to remove the stud. Therefore, i'm going to be doing a full rebuild along with a mild port job and then take it somewhere for a basic valve-job. So yet another delay in my efforts to boost the bastard :cry: . My question is... where is the best place to buy rebuild parts for the head? I'm planning to tackle this after i complete the transmission/transfercase replacements i'm doing.
-
Try Jeg's (http://www.jegs.com/). May want to call them, a lot of thier inventory is not on thier site.
-
I know this is too late for ya... but I was always told to heat up stuck exhaust suds till they are red hot - then quench them with water to break 'em loose.
For parts -
I'm a Summit fan. BTW - If you get there credit card and spend $500 you get 360 days to pay it off interest free.
-
How much did yours leak when you attempted to replace it? Mine makes noise when the engine is started but in 2-3 minutes the noise stops and I can no longer feel the air leaking under the hood. Any idea how long it will be until the leak gets worse?
-
I didn't hear a leak at all, and visually there is only minor sud on around that part of the gasket... But once i turbo it, that leak will most likely get worse and slow down my spool-time. I'm not sure how long till the leak beings to worsen, it may not.
I'll try summit and jegs, thanks for the info on the credit card thing too. :)
-
What kind of a turbo are you putting on it?
-
I've mentioned it in a few threads. It is a DSM 14b... not sure when i'm going to get around to it though at the rate i'm going :lol:
-
Working on these Jeeps is time consuming, I agree.
-
especially when you are only working on it once a weekend, and for only half a day lol. work/school/girlfriend and the jeep being half an hour from where i stay is killing me.