4bangerjp.com

General Forums => The Mess Hall => Topic started by: Clem on April 08, 2008, 09:50:43 PM

Title: Throw-out bearing retainer clip...
Post by: Clem on April 08, 2008, 09:50:43 PM

Does anyone have a good exploded diagram of the exact location of the throwout bearing retainer clip? It has been a LONG time since I messed with pulling this monster apart... Thanks.

Title: Re: Throw-out bearing return spring...
Post by: Clem on April 09, 2008, 08:09:21 AM

(http://shopping.jeep4x4center.com/images/23A.jpg)

I am trying to get part #12 figured out...    :brick:

(http://www.quadratec.com/Assets/Images/76527/76527-md.jpg)

Title: Re: Throw-out bearing retainer clip...
Post by: gkainz on May 30, 2008, 10:22:09 PM

I just put part #12 back on yesterday - could NOT reach around the arm (#3) to get the spring to latch over the stud (#5) so I removed the nut from the back of #5, installed the retainer spring and arm to the stud and then slid the whole thing into the bellhousing and tightened the nut on the back of the stud.