4bangerjp.com
General Forums => The Mess Hall => Topic started by: Yellowcritter on June 29, 2008, 12:12:37 AM
-
Any one know the factory tooth count on the seedo gear for a 2000 SE TJ? The gearing was 4.11 and I think it came with 215R75/15 tires (approx. 29"). I pulled out a 39 tooth gear orginally but that doesn't match what all the gear charts say.
Basically, I trying to figure what gear to run with 35" tires and 4.56 gears.
-
Stock is usually 41T. You want a 37T like what I'm using.
-
41T makes since for stock on the gear charts, wonder why I would of had a 39. Have you ever put a GPS to yours?
Stock is usually 41T. You want a 37T like what I'm using.
-
41T makes since for stock on the gear charts, wonder why I would of had a 39. Have you ever put a GPS to yours?
You may of had a 39T if you had the optional tires, I think. Those are slightly larger then the stock 205's.
I run my GPS all the time. It's accurate with in 1mph.
-
Thanks for the help
You may of had a 39T if you had the optional tires, I think. Those are slightly larger then the stock 205's.
I run my GPS all the time. It's accurate with in 1mph.
-
My 29" (235/75R15) tires used a 40 tooth speedo gear. This is the chart I used when I upgraded to 33's. Afterward I used the USGS Natianal Map View to measure a section of road and calculated the time to travel it at 60 MPH. After I ran it once, it was PERFECT!!! No GPS for me. :(
http://www.quadratec.com/jeep_knowledgebase/article-46.htm