4bangerjp.com

General Forums => The Mess Hall => Topic started by: donut on October 09, 2008, 05:36:14 PM

Title: tranny swap questions
Post by: donut on October 09, 2008, 05:36:14 PM

 :asshat:
 im havin a hard time decifering that swap page (jarheads aint smart), what all do i need to swap an ax15 into my jeep?  its a 95 4 cyl.  i know i need a 96-00 dakota bellhousing, but after that, i dunno.  the ax15's is out of a 91 4.0 wrangler.   cheers.  :beers:

Title: Re: tranny swap questions
Post by: aw12345 on October 09, 2008, 05:44:12 PM

It depends on the slave cylinder setup ax5 has one inside the bellhousing, some of the ax15's do and some do not.
Also some folks have a lot of fun finding the correct pilot bushing I.E this is where the front of the transmission unput shaft runs in the back of the crankshaft is a small bronze bushing but ithas to be the correct size for long clutch disc life

Title: Re: tranny swap questions
Post by: donut on October 09, 2008, 06:34:59 PM

 :asshat:
i think it has an external slave cylinder.  ive been wrong before.  ask my wife.  has anyone out there done this swap?  any tips?  okay, so i need the dakota bellhousing, and find or make the correct pilot bushing...any measurements, length, OD, ID...? anything else ill need?  ive heard this swap is relativley easy...