4bangerjp.com

General Forums => The Mess Hall => Topic started by: smashcoast on December 03, 2008, 08:35:14 PM

Title: Hi-Jack mounting?
Post by: smashcoast on December 03, 2008, 08:35:14 PM

I see 2 different types of mounting kits.

http://www.4wd.com/productdetails.aspx?partID=7047

http://www.4wd.com/productdetails.aspx?partID=13928

do they mount the same? If so i want to be able to lock it.

I'm going to mount it on the inside of my tire swing, so does anyone know which one is better?

Title: Re: Hi-Jack mounting?
Post by: chardrc on December 03, 2008, 08:58:42 PM

I've always liked them mounted between the rear roll bar... there is a thread about it somewhere on the forum...

Title: Re: Hi-Jack mounting?
Post by: FourbangerYJ on December 03, 2008, 10:22:52 PM

Quote from: smashcoast on December 03, 2008, 08:35:14 PM

I see 2 different types of mounting kits.

http://www.4wd.com/productdetails.aspx?partID=7047

This one says it will mount on flat surfaces 2.5 x 2.5 inches.

http://www.4wd.com/productdetails.aspx?partID=13928

This one does not say. But it looks like you need a flat surface to mount it to.

do they mount the same? If so i want to be able to lock it.

I'm going to mount it on the inside of my tire swing, so does anyone know which one is better?

Which one is better my depend on your swing out. Both are lockable.

Title: Re: Hi-Jack mounting?
Post by: oldjeep on December 04, 2008, 05:42:53 AM

The second one rattles a lot.    If you use your jeep as a daily driver I'd recommend putting the hi-lift inside so that it works when you need it.