4bangerjp.com

General Forums => The Mess Hall => Topic started by: 01amberfirewv on November 30, 2005, 08:21:03 PM

Title: anyone running a M.O.R.E 1" body lift
Post by: 01amberfirewv on November 30, 2005, 08:21:03 PM

I just picked up a used one.  Seems like quality stuff with all metal hardware.  How do you like yours?  How hard was the install?  Do you have any pics?

I plan on adding a MML after I get the BL installed.  What is the best one for a 2.5?

Title: anyone running a M.O.R.E 1" body lift
Post by: Jeffy on November 30, 2005, 08:36:01 PM

I was going to get a MORE set but decided against it when the JKS/Currie were on sale. :roll:

Title: anyone running a M.O.R.E 1" body lift
Post by: jagular7 on November 30, 2005, 09:07:57 PM

I have someone's which I don't recall whose. But here is a couple of suggestions:
- there are 2 body mounts above the rear axle, don't forget about those.
- while the body is off the frame, add the front grille spacer as there is room for your hands then.

Title: anyone running a M.O.R.E 1" body lift
Post by: shotgun on December 01, 2005, 07:26:36 AM

Most people around my neck of the woods have a poly 1" bodylift.  Since it's replacing the whole body bushing.

Title: anyone running a M.O.R.E 1" body lift
Post by: SMC4WD on December 01, 2005, 09:11:52 AM

I'm running a Daystar 1" bushing kit, with a 1" MML by the same company.  We had to do some custom modificatons to the 4.0L MML to make it work on a 2.5L.  I had wished that I used the MORE MML instead of Daystar only because it's rubber instead of the polyuthane bushings.

This didn't answer your question, it's just input.

MORE does a fantastic job, and you should be very satisfied.