4bangerjp.com

General Forums => The Mess Hall => Topic started by: cletz97 on March 26, 2009, 08:33:52 AM

Title: daily driver
Post by: cletz97 on March 26, 2009, 08:33:52 AM
I was looking for suggestion for power
things like tire size, gears, upgrades
what would be good for moderate power on the highway, and then be good for off road also?
also not looking for anything to expensive, like anything over 1000 is out of the question.
thanks
Title: Re: daily driver
Post by: jfrabat on March 26, 2009, 09:48:06 AM
I will assume you have a TJ; then things to do could be


Hope this helps pointing you in the right direction!

Felipe
Title: Re: daily driver
Post by: cletz97 on March 26, 2009, 12:12:25 PM
how do you go about installing a new cam?
do u have to take apart the engine?
and how much would that be?
parts? and if i couldn't labor?
Title: Re: daily driver
Post by: Jeffy on March 26, 2009, 01:48:34 PM
My suggestions;  Run 31x9.5R15 or 31x10.5R15's.  Keep the suspension stock.  Lift and large tires will kill your mileage at high speeds.  If you have an automatic then swap axles to 2.5L Manual to get 4.10/4.11's.  I'd switch over to a electrical fan so the engine doesn't have to work as much.  The engine will spool up faster as well.  Maybe do a 4.0L TB conversion.  That will give you a crisper throttle and get more air in at WOT.  Swap the injectors over to 24# (TJ) will smooth out the idle and should give you a bit more torque and mileage.  I'd go with the Performance Distributors Ignition since ti's easy to install and works well.  Stock plug gap is .035".  With the PD setup, you can regap safely at .065".  I haven't tried to go any wider, yet.

If you wanted larger tires then I would go with 33x10.5R15's or the metric equivalent on a 16" wheel.  16" wheels have more skinny tires available then with the Standards.  Keeping them narrow will cut down in wind resistance, and weight as well their rolling resistance.  You'll need a bit of a lift though.  Probably gi with a 2" budget boost.  On teh expensive end, I'd look at ACOS system as it's completely adjustable.

Personally, I'd leave the cam for last if ever.  Cams are pretty expensive since and a bit labor intensive if you're not a shade tree mechanic.  If you do your own work, you can really stretch your money far.  If you have people do the work then it won't go very far.  Probably half will go to labor depending on the job.
Title: Re: daily driver
Post by: cletz97 on March 30, 2009, 12:29:35 PM
Thank you that cleared up a lot.
and i have a manual trans so those axles are good right?
Title: Re: daily driver
Post by: Jeffy on March 30, 2009, 04:02:02 PM
Thank you that cleared up a lot.
and i have a manual trans so those axles are good right?
They're OK if you don't drive like you stole it.  The D35c gets a lot of flack but it's strength is really hit or miss.  Sometimes you get a good once.  Even if you don't, as long as you drive with that inmind you shouldn't have any problems.
Title: Re: daily driver
Post by: rubberducky on March 30, 2009, 06:28:52 PM
I've got 05 tj with D35. Just blew out the ring gear. 100k miles and rode hard and put up wet. Pulling loads no jeep should. I think the cause to the axle going out is me having to down shift to slow down fast in traffic. People down here in Houston can't drive for poop. specially if you have a trailer. Cam is not too hard but you need to know some engine knowledge. other than that these guys covered it. Oh I was running 3.73 with 31x9.5 I ran that for like 80k no problem. averaged 16-18 mpg.