4bangerjp.com

General Forums => The Mess Hall => Topic started by: Mozman68 on June 27, 2010, 10:24:16 AM

Title: Air inlet tube
Post by: Mozman68 on June 27, 2010, 10:24:16 AM

Any advice on removing the air inlet tube on top of the engine block?

I have a new one to replace the old one and not sure if I have toremove the rubber gasket as well as the tube itself.

Title: Re: Air inlet tube
Post by: Mozman68 on June 27, 2010, 03:13:01 PM

ow can something so hard to get out be so easy to put in.....

(http://i114.photobucket.com/albums/n254/faustus777/TheOffice-ThatsWhatSheSaid-Michael.jpg)


Practically destroyed the part, but new one is in and Jeep is running better than ever. :thumbsup:

Title: Re: Air inlet tube
Post by: Mozman68 on June 27, 2010, 03:15:21 PM

...also...took the throttle body off for the first time.  Was having a stalling issue when stopped or sometimes when pushing in the clutch to make a turn at slower speeds.

Cleaned out the whole throttle body as well as the IAC....seemed to do the trick!   :thumbsup: