4bangerjp.com

General Forums => The Mess Hall => Topic started by: redYJrider on October 25, 2010, 01:06:07 PM

Title: Powertrax No-Slip Installation Help
Post by: redYJrider on October 25, 2010, 01:06:07 PM
I'm gettin ready to install a used Powertrax No-Slip into the rear of my 90YJ. I'm missing the check block though. Does anyone know the dimensions of this check block? I can't seem to get a response from Richmond Gear.    :brick:
Title: Re: Powertrax No-Slip Installation Help
Post by: Jeffy on October 25, 2010, 01:18:03 PM
I'm gettin ready to install a used Powertrax No-Slip into the rear of my 90YJ. I'm missing the check block though. Does anyone know the dimensions of this check block? I can't seem to get a response from Richmond Gear.    :brick:
Did you try contacting the place you bought the locker from?
Title: Re: Powertrax No-Slip Installation Help
Post by: redYJrider on October 25, 2010, 01:28:15 PM
Did you try contacting the place you bought the locker from?

Ebayer wasn't familier with it.
Title: Re: Powertrax No-Slip Installation Help
Post by: Jeffy on October 25, 2010, 01:36:34 PM
Was it used?  In any case I'd call Richmond Gears if you haven't already.  Emails don't always get checked.
Title: Re: Powertrax No-Slip Installation Help
Post by: redYJrider on October 25, 2010, 01:56:26 PM
Was it used?  In any case I'd call Richmond Gears if you haven't already.  Emails don't always get checked.

Yes it's used. I'll try calling Richmond Gear again in a little while.
Title: Re: Powertrax No-Slip Installation Help
Post by: chardrc on October 25, 2010, 03:15:38 PM
powertrax 92-0435-2705 for d35 1990-1993. got the same locker in my jeep pulled out the checker from the box and got these dimensions.

wide side(max allowable): 0.165 in
thin side (minimum allowable): 0.132 in

hope this helps
Title: Re: Powertrax No-Slip Installation Help
Post by: redYJrider on October 25, 2010, 03:32:12 PM
powertrax 92-0435-2705 for d35 1990-1993. got the same locker in my jeep pulled out the checker from the box and got these dimensions.

wide side(max allowable): 0.165 in
thin side (minimum allowable): 0.132 in

hope this helps

That's what I'm looking for. Thank you!