« previous next »
Pages: [1]   Go Down

Author Topic: tranny swap questions  (Read 559 times)

0 Members and 1 Guest are viewing this topic.

donut

  • Guest
tranny swap questions
« on: October 09, 2008, 05:36:14 PM »
 :asshat:
 im havin a hard time decifering that swap page (jarheads aint smart), what all do i need to swap an ax15 into my jeep?  its a 95 4 cyl.  i know i need a 96-00 dakota bellhousing, but after that, i dunno.  the ax15's is out of a 91 4.0 wrangler.   cheers.  :beers:
Logged

Offline aw12345

  • Member
  • Posts: 3065
    • my jeep picture page
Re: tranny swap questions
« Reply #1 on: October 09, 2008, 05:44:12 PM »
It depends on the slave cylinder setup ax5 has one inside the bellhousing, some of the ax15's do and some do not.
Also some folks have a lot of fun finding the correct pilot bushing I.E this is where the front of the transmission unput shaft runs in the back of the crankshaft is a small bronze bushing but ithas to be the correct size for long clutch disc life
Logged
2006 Jeep Wrangler TJ SE
2004 Jeep Wrangler TJ SE

donut

  • Guest
Re: tranny swap questions
« Reply #2 on: October 09, 2008, 06:34:59 PM »
 :asshat:
i think it has an external slave cylinder.  ive been wrong before.  ask my wife.  has anyone out there done this swap?  any tips?  okay, so i need the dakota bellhousing, and find or make the correct pilot bushing...any measurements, length, OD, ID...? anything else ill need?  ive heard this swap is relativley easy... 
Logged
Pages: [1]   Go Up
« previous next »