Topic: cleaning iat

[pioneer4x4]

i have an 86 xj 2.5l tbi and was gonna clean the intake air temperature sensor since it is pretty nasty and a new one is not available at any parts stores around. i was wondering if i could clean it with this crc lectra-motive electric parts cleaner i have? my only concern is it states that you shouldn't use it on polycarbonate plastics such as lexan? not real sure what all that means, and the iat sensor has a plastic housing? is it polycarbonate? thanks in advance.

[sharpxmen]

not sure what is made of but if it's just nasty you can use soap and water (or vehicle shampoo and water) and a soft brush (a soft paint brush would do so you can get in all the little spots) - that should be safe, and just blow it dry. I was to suggest pump gas but again not sure if the housing is resistant to that (should be, but you never know).

[chardrc]

if it wasn't gas resistant i would think it would be totally eaten by now since it is in the manifold after the gas is injected into the air and its lasted 23 years...

[sharpxmen]

if it wasn't gas resistant i would think it would be totally eaten by now since it is in the manifold after the gas is injected into the air and its lasted 23 years...

i think he was worried for the housing by the electrical connector (i assume that's what he wanted to wash since he mentioned that cleaning product)

[pioneer4x4]

thanks for the replys, i was talking about the end that goes into man. but im gonna clean both ends. thanks