« previous next »
Pages: [1] 2   Go Down

Author Topic: passanger side inner axle seal  (Read 2424 times)

0 Members and 2 Guests are viewing this topic.

Dynamic4x4

  • Guest
passanger side inner axle seal
« on: August 21, 2011, 09:23:35 AM »
ok so i replaced the 2 piece axle shaft a few years back to a single piece one but now its leaking :brick: i tried to install a new seal in the passanger side of the axle tube right beside the carrier and it bent all to heck installing and is still leaking after searching on here ive seen that there isnt a seal for this location on the 2 piece shafts so do i just need to replace the one where the disconnect box use to be?  does anyone have the part number for that seal?
Logged

Offline grumpygy

  • Member
  • Posts: 882
Re: passanger side inner axle seal
« Reply #1 on: August 21, 2011, 09:42:39 AM »
They have the other years and models too.  on this one look at #26.

http://www.quadratec.com/jeep-replacement-parts/jeep-axles-differentials/yj-dana-30-front.php
Logged
94 YJ, Cool Air intake, 19lb Inj, 4.0 Throttlebody with spacer,  31/10.50/15's

Dynamic4x4

  • Guest
Re: passanger side inner axle seal
« Reply #2 on: August 21, 2011, 10:37:28 AM »
thats the one i tryed to put in it this last time and its still leaking do you know if it would maybe go by what the shaft itself is out of? only problem with that is i have no clue what they took it out of other than i believe they said it was a cherokee
Logged

Offline grumpygy

  • Member
  • Posts: 882
Re: passanger side inner axle seal
« Reply #3 on: August 21, 2011, 11:21:13 AM »
Just maybe since youbent the 1st one up maybe you should put in one not bent.
Logged
94 YJ, Cool Air intake, 19lb Inj, 4.0 Throttlebody with spacer,  31/10.50/15's

Offline sharpxmen

  • Chief Squirrel BlowerŪ
  • Member
  • *
  • Posts: 7093
Re: passanger side inner axle seal
« Reply #4 on: August 21, 2011, 01:52:31 PM »
Quote from: grumpygy on August 21, 2011, 11:21:13 AM
Just maybe since youbent the 1st one up maybe you should put in one not bent.
x2, if it was bent would leak
Logged
'95 YJ, NSG370 6spd / Hurst shifter, Dana 300 + 4:1 Doubler / tri-stick, Custom skid, Super D35 / Auburn LSD / 4.88, 35x12.5x15 BFG KM2, 64mm t/b, 1.7 RollerRockers, MkVIII e-fan, Dual Diaph Booster
Latest: Corbeau BajaRS heated seats :dance: keeping warm the rear end

Offline chardrc

  • Member
  • Posts: 3535
Re: passanger side inner axle seal
« Reply #5 on: August 21, 2011, 06:24:37 PM »
I've heard that there are multiple different diameters of seals for the passenger side of the carrier. figuring out which one your axle needs is the hard part. (ounce you find the kist of what possible seals it could be)
Logged
1990 YJ 4cly, ax5, 2.5 inch BDS lift, 31 MTr\'s,  Powertrax-lockers all around, track-bars removed, boomerang shackles, warn m8000 winch, electric fan. [sold but not forgotten]

2007 jk Rubicon 2dr

Offline sharpxmen

  • Chief Squirrel BlowerŪ
  • Member
  • *
  • Posts: 7093
Re: passanger side inner axle seal
« Reply #6 on: August 21, 2011, 08:42:36 PM »
if it's the wrong ID should be easy to check.
Logged
'95 YJ, NSG370 6spd / Hurst shifter, Dana 300 + 4:1 Doubler / tri-stick, Custom skid, Super D35 / Auburn LSD / 4.88, 35x12.5x15 BFG KM2, 64mm t/b, 1.7 RollerRockers, MkVIII e-fan, Dual Diaph Booster
Latest: Corbeau BajaRS heated seats :dance: keeping warm the rear end

Offline neale_rs

  • Member
  • Posts: 3583
Re: passanger side inner axle seal
« Reply #7 on: August 22, 2011, 09:56:25 AM »
This is the info I've run across: 471763 a National number same for Carquest and Oriellys
Logged
'95 YJ, 33 x 12.5 mud tires, RE 4.5 ED lift, Atlas 4 speed, rear D44, ARBs front and rear, 4.56 gears, 8000# winch

Dynamic4x4

  • Guest
Re: passanger side inner axle seal
« Reply #8 on: August 22, 2011, 12:49:52 PM »
yea i gess i have the wrong ID for it becouse it didnt just bend on one side the whole lip after the step up bent in i to make itself smaller im gonna pull it apart this weekend and see if i can find a way to measure the ID of it then comes the fun part of trying to find the right one parts are a pita to find in germany thanks for all the help
Logged

Offline neale_rs

  • Member
  • Posts: 3583
Re: passanger side inner axle seal
« Reply #9 on: August 22, 2011, 12:52:20 PM »
Quote from: neale_rs on August 22, 2011, 09:56:25 AM
This is the info I've run across: 471763 a National number same for Carquest and Oriellys


This is one that goes in the axle disconnect housing when using a TJ shaft in a YJ D30.
« Last Edit: August 22, 2011, 01:34:13 PM by neale_rs »
Logged
'95 YJ, 33 x 12.5 mud tires, RE 4.5 ED lift, Atlas 4 speed, rear D44, ARBs front and rear, 4.56 gears, 8000# winch

Offline sharpxmen

  • Chief Squirrel BlowerŪ
  • Member
  • *
  • Posts: 7093
Re: passanger side inner axle seal
« Reply #10 on: August 22, 2011, 01:07:33 PM »
i'm pretty sure the 2 piece axle uses 2 seals on the passenger side, with a 1 piece you only need the inner one if i'm not mistaking.
Logged
'95 YJ, NSG370 6spd / Hurst shifter, Dana 300 + 4:1 Doubler / tri-stick, Custom skid, Super D35 / Auburn LSD / 4.88, 35x12.5x15 BFG KM2, 64mm t/b, 1.7 RollerRockers, MkVIII e-fan, Dual Diaph Booster
Latest: Corbeau BajaRS heated seats :dance: keeping warm the rear end

Offline sharpxmen

  • Chief Squirrel BlowerŪ
  • Member
  • *
  • Posts: 7093
Re: passanger side inner axle seal
« Reply #11 on: August 22, 2011, 03:19:39 PM »
Quote from: sharpxmen on August 22, 2011, 01:07:33 PM
i'm pretty sure the 2 piece axle uses 2 seals on the passenger side, with a 1 piece you only need the inner one if i'm not mistaking.

i'm not so sure about my statement above anymore, i will look in the FSM to see if i can find a parts list, seems that they use only 1 seal in the disco housing on the ones with axle disconnect, i have no idea if you can actually install one in the diff housing like in the TJs with 1 piece axle, if the axle does not have the seal seat machined for the disconnect seal position then would probably leak.
Logged
'95 YJ, NSG370 6spd / Hurst shifter, Dana 300 + 4:1 Doubler / tri-stick, Custom skid, Super D35 / Auburn LSD / 4.88, 35x12.5x15 BFG KM2, 64mm t/b, 1.7 RollerRockers, MkVIII e-fan, Dual Diaph Booster
Latest: Corbeau BajaRS heated seats :dance: keeping warm the rear end

Offline neale_rs

  • Member
  • Posts: 3583
Re: passanger side inner axle seal
« Reply #12 on: August 22, 2011, 05:42:29 PM »
I have read in various forums that some YJ D30 have a seat by the diff and some do not.  In any case, it seems the safe bet is to put a seal at the disco housing anytime TJ shafts are used.
Logged
'95 YJ, 33 x 12.5 mud tires, RE 4.5 ED lift, Atlas 4 speed, rear D44, ARBs front and rear, 4.56 gears, 8000# winch

Offline sharpxmen

  • Chief Squirrel BlowerŪ
  • Member
  • *
  • Posts: 7093
Re: passanger side inner axle seal
« Reply #13 on: August 22, 2011, 07:10:32 PM »
Quote from: neale_rs on August 22, 2011, 05:42:29 PM
I have read in various forums that some YJ D30 have a seat by the diff and some do not.  In any case, it seems the safe bet is to put a seal at the disco housing anytime TJ shafts are used.

would the 1 piece shaft have the smooth surface for the seal in that place to properly seal (couldn't avoid the repetition) since is supposed to have the seal by the diff?
Logged
'95 YJ, NSG370 6spd / Hurst shifter, Dana 300 + 4:1 Doubler / tri-stick, Custom skid, Super D35 / Auburn LSD / 4.88, 35x12.5x15 BFG KM2, 64mm t/b, 1.7 RollerRockers, MkVIII e-fan, Dual Diaph Booster
Latest: Corbeau BajaRS heated seats :dance: keeping warm the rear end

Offline neale_rs

  • Member
  • Posts: 3583
Re: passanger side inner axle seal
« Reply #14 on: August 23, 2011, 08:00:23 AM »
I think the aftermarket axles sold as "disconnect eliminator" have a proper sealing surface, but not the stock TJ shafts.
Logged
'95 YJ, 33 x 12.5 mud tires, RE 4.5 ED lift, Atlas 4 speed, rear D44, ARBs front and rear, 4.56 gears, 8000# winch
Pages: [1] 2   Go Up
« previous next »