« previous next »
Pages: [1]   Go Down

Author Topic: Coil  (Read 1617 times)

0 Members and 2 Guests are viewing this topic.

Offline grumpygy

  • Member
  • Posts: 882
Coil
« on: June 03, 2011, 06:41:37 PM »
Ok did not read the other topic and went with Pertronix Oil Filled 3.0 OHM 40,000 Volt Flame Thrower Ignition Coil .  When I drive to work 25 Miles in the Morning and its cool the jeep runs fine or at least better.  But coming back in the afternoon it starts cutting out and missing badly.

  So is this coil a direct bolt in or do I need some resistor  for it.  It felt warm to Hot today when I got home.    I still have fuel problems I believe.  But will be draining the tank and dropping it to make sure its clean.
Logged
94 YJ, Cool Air intake, 19lb Inj, 4.0 Throttlebody with spacer,  31/10.50/15's

Offline grumpygy

  • Member
  • Posts: 882
Re: Coil
« Reply #1 on: June 03, 2011, 10:17:34 PM »
Ok did some searching and should I have gottern the 1.5 Ohms coil instead.  Most of what I find is 1.0 -1.5 after market coils listed for the 2.5 with stock Ignition.
Logged
94 YJ, Cool Air intake, 19lb Inj, 4.0 Throttlebody with spacer,  31/10.50/15's

Offline grumpygy

  • Member
  • Posts: 882
Re: Coil
« Reply #2 on: June 04, 2011, 07:24:08 PM »
Could somebody verify that I'm on the right track with the coil and the OHMS.
Logged
94 YJ, Cool Air intake, 19lb Inj, 4.0 Throttlebody with spacer,  31/10.50/15's

Offline sharpxmen

  • Chief Squirrel BlowerŪ
  • Member
  • *
  • Posts: 7093
Re: Coil
« Reply #3 on: June 04, 2011, 07:54:03 PM »
Quote from: grumpygy on June 04, 2011, 07:24:08 PM
Could somebody verify that I'm on the right track with the coil and the OHMS.

why don't you buy a direct replacement?
Logged
'95 YJ, NSG370 6spd / Hurst shifter, Dana 300 + 4:1 Doubler / tri-stick, Custom skid, Super D35 / Auburn LSD / 4.88, 35x12.5x15 BFG KM2, 64mm t/b, 1.7 RollerRockers, MkVIII e-fan, Dual Diaph Booster
Latest: Corbeau BajaRS heated seats :dance: keeping warm the rear end

Offline grumpygy

  • Member
  • Posts: 882
Re: Coil
« Reply #4 on: June 04, 2011, 09:39:16 PM »
Quote from: sharpxmen on June 04, 2011, 07:54:03 PM
why don't you buy a direct replacement?

  This one was listed for my jeep.  I am going to put back in a stock one.  I can always use this one on my VW.  Buit I would still like to know what OHM the coil is supposed to be.  Cause I've seen stock vary.
Logged
94 YJ, Cool Air intake, 19lb Inj, 4.0 Throttlebody with spacer,  31/10.50/15's

Offline grumpygy

  • Member
  • Posts: 882
Re: Coil
« Reply #5 on: June 06, 2011, 06:47:35 PM »
New stock coil installed so far so good.  Will know more after I drive to work tomorrow.
Logged
94 YJ, Cool Air intake, 19lb Inj, 4.0 Throttlebody with spacer,  31/10.50/15's

Offline grumpygy

  • Member
  • Posts: 882
Re: Coil
« Reply #6 on: June 07, 2011, 05:35:29 PM »
It was the coil.
Logged
94 YJ, Cool Air intake, 19lb Inj, 4.0 Throttlebody with spacer,  31/10.50/15's
Pages: [1]   Go Up
« previous next »