4bangerjp.com

General Forums => The Mess Hall => Topic started by: underwhelmd on October 25, 2007, 03:44:27 PM

Title: Crank position sensor
Post by: underwhelmd on October 25, 2007, 03:44:27 PM
On a 94 YJ 2.5...  I can see it but how many hoops will I be jumping through to remove it and replace it with new?   Go in from the top or underneath?   Any advice would be appreciated as I heard it was a terrible job.

thanks.
Title: Re: Crank position sensor
Post by: oldjeep on October 25, 2007, 04:12:30 PM
From underneath it's a 10 minute job.  Just need a short 10mm socket
Title: Re: Crank position sensor
Post by: Jeffy on October 25, 2007, 04:19:55 PM
Quote from: oldjeep on October 25, 2007, 04:12:30 PM
From underneath it's a 10 minute job.  Just need a short 10mm socket

That's included time to talk, have a beer and go to the bathroom...   :lol:
Title: Re: Crank position sensor
Post by: neale_rs on October 30, 2007, 06:19:32 PM
Install a body lift first.  :yikes:  Ha, ha, just kidding!
Title: Re: Crank position sensor
Post by: van on October 30, 2007, 06:42:20 PM
Underneath.  2 bolts.  You'll spend longer washing your hands afterward than you did replacing it.

Be careful with the connector.