4bangerjp.com
General Forums => The Mess Hall => Topic started by: Complete Loser on March 25, 2010, 10:43:31 AM
-
Well, i put on a pacesetter header, a tb spacer, and a 4.0 throttle body. Along with a 130a alt. She runs, but doesnt start or run as good as i would have hoped.
The idle is very smooth and at about 900rpm.
I bought a new TPS for my 2.5 tb and went ahead and put it in this 4.0 tb. Now i am getting a tps code (24). Just wondering if i need to go back to the original 4.0 tb sensor?
The other codes are
12 and 33
-
Well, i put on a pacesetter header, a tb spacer, and a 4.0 throttle body. Along with a 130a alt. She runs, but doesnt start or run as good as i would have hoped.
The idle is very smooth and at about 900rpm.
I bought a new TPS for my 2.5 tb and went ahead and put it in this 4.0 tb. Now i am getting a tps code (24). Just wondering if i need to go back to the original 4.0 tb sensor?
The other codes are
12 and 33
i would take the tps back and get another one
swap the IAC valve and housing as well
-
I was going to swap the IAC. I pulled them both off, and they both looked a good bit different internally. The 'plunger' part of them looked bigger on the 4.0. ? So i left them on their respective throttle bodies.
-
I was going to swap the IAC. I pulled them both off, and they both looked a good bit different internally. The 'plunger' part of them looked bigger on the 4.0. ? So i left them on their respective throttle bodies.
you need the 2.5L IAC valve and housing on the 4.0 t/b - the 4.0 require a lot more air at idle than the 2.5 that's why they are different.
-
Im such a gomer. I didnt even notice that the housing was removable. Thanks.... yet.... again.
I feel like i should be paying you guys. How bout a round of beers? :beer:
-
Awesome! Those require the torx bits with the hole in the middle! :clap: Now this is turning out like a normal vehicle project. :weee: Off to get some bits. lol
-
Im such a gomer. I didnt even notice that the housing was removable. Thanks.... yet.... again.
I feel like i should be paying you guys. How bout a round of beers? :beer:
if you're ever in Vancouver i'll take you up on that
not sure if it will fix your tps code though, but i would at least reset the computer.
-
Awesome! Those require the torx bits with the hole in the middle!
there called tamper prof torx
-
yup. just bought some of the torx bits. They sure are proud of them. $23 for about 7 bits.
How do i reset the codes on the computer.
-
yup. just bought some of the torx bits. They sure are proud of them. $23 for about 7 bits.
How do i reset the codes on the computer.
remove the ground from battery, touch it to the + and leave it off for 5 minutes.