4bangerjp.com
General Forums => The Mess Hall => Topic started by: rocktime on August 25, 2010, 10:30:27 AM
-
i have the 97 wrangler with the ax5 and my np231 transfercase is not sounding to good making alot of new sounds. i was wondering if anyone has taken the tranfercase out of the rubicon the nvg241or and put it behind there ax5. any help would be great.
-
i have the 97 wrangler with the ax5 and my np231 transfercase is not sounding to good making alot of new sounds. i was wondering if anyone has taken the tranfercase out of the rubicon the nvg241or and put it behind there ax5. any help would be great.
The AX5 has a 21 spline output. The NVG241 has a 23 spline input. I don't know if anyone makes a spud shaft and adapter to mate the two.
You could do a AX15 conversion then add the 241.
-
I would imaging the 21spl input shaft from the 231 would fit inside the 241or, then they'd bolt up.
I'm not a fan of 4:1 low transfer for wheelin here in the Midwest, but I guess it's all in how you set up the rest of your drivetrain and what you're going to do with it.
-
Check out JB Conversions' beefed up NP231J case: 6 pinion planetary, fat chain, and ultra short shaft slip yoke eliminator. Just a thought.
Wheezer
-
I would imaging the 21spl input shaft from the 231 would fit inside the 241or, then they'd bolt up.
I haven't heard of anyone doing this but it would be cool if it worked. Maybe send an email off to Novak (http://www.novak-adapt.com/) and see if they have any insight.