Topic: Finally dived into the repair work I needed (well, I started, anyway!)

[Jeffy]

Where's the plug location and what colors are they?  One purple?  Could be for the cigarette lighter for the stock location.  The stock location won't reach the A/C location.

[jfrabat]

Where's the plug location and what colors are they?  One purple?  Could be for the cigarette lighter for the stock location.  The stock location won't reach the A/C location.

Black and red: they come from the same bunch of cables as those that connect to the heater/ventilation system.

[Jeffy]

Well, the stock ash tray mounts right below the Heater Vent controls.  I'd just tie them up if you're not going to use them.

[sharpxmen]

i'm not positive on the flow rate, you'll have to test and see if you can, you can compare one of them with a stocker, same rail running into some bottles (injectors opened and measure the fuel quantity) or just install them and see how it goes. I ran 43 psi and didn't have any problems starting it (actually i even had it all the way close to 50 but was blowing black smoke but was starting just fine) so i don't think that's your problem.

[jfrabat]

Well, the stock ash tray mounts right below the Heater Vent controls.  I'd just tie them up if you're not going to use them.

I'm sure I can find a use for them...  It's just good to know what they are.

i'm not positive on the flow rate, you'll have to test and see if you can, you can compare one of them with a stocker, same rail running into some bottles (injectors opened and measure the fuel quantity) or just install them and see how it goes. I ran 43 psi and didn't have any problems starting it (actually i even had it all the way close to 50 but was blowing black smoke but was starting just fine) so i don't think that's your problem.

I think I will just install them and see how it goes...