Topic: axle throwdown. super35, 8.8, d44

[smashcoast]

ya i wouldnt buy there shafts or alloy usa, i have heard to much negative stuff about them.

Superior seems to be the way to go.

[No Luck]

I just put an 8.8 LSD in and the LSD locks up just like a full locker.

That's funny! No way in hell is a LSD is going to lock up like a locker.

[reddogg]

This is probably already readily known but here's a link to lookup parts. Seems good. Anyone with experience using it please input. I'm debating an 8.8 for my yj when funds are available.
http://www.car-part.com/index.htm

[chrisfranklin]

Read that the Detroit in the Super 35 holds 30 spline axle shafts.  

With that in mind, would it be possible to utilize a lunchbox locker, say an Aussie, designed for the
D44/ 30-spline shafts (one piece axles) and just fit that and 30 spline shafts in the D35 (similar to the Detroit/axle setup in the Super 35)?  

Pretty sure that apart from a change to the Aussie's design to accommodate 30 spline shafts, the D44 Aussie has the same overall dimensions as the D35 Aussie

So, this would be a sort of lower-buck, partial Super 35...  

So, is this theoretically possible (if maybe no where near as wise as a full-on swap to a D44 or 8.?