Author Topic: Has anyone re-wired their Jeep?  (Read 580 times)

0 Members and 1 Guest are viewing this topic.

Offline bootguy

  • Member
  • Posts: 117
  • TANSTAAFL There Aint No Such Thing As A Free Lunch
Has anyone re-wired their Jeep?
« on: April 10, 2015, 12:16:08 AM »
I have been fixing wiring issues on my jeep for a while now.  Has anyone done a complete re-wire using pre made wiring harnesses?  My fuse block in the cab needs to be repaired/replaced as some contacts have broken.  The fuse block in the engine compartment is cracked and broken and have used duct tape to keep water/moisture out.  Since I have quite a bit more to fix just wondering if complete replacement is as easy as the vendors claim?
1994 Jeep Wrangler, 2.5L, automatic, 2.5" lift, 4:88 gearing, 33" tires, 2.5" exhaust from manifold back, air restrictor removed.

Offline sharpxmen

  • Chief Squirrel BlowerŪ
  • Member
  • *
  • Posts: 7093
Re: Has anyone re-wired their Jeep?
« Reply #1 on: April 10, 2015, 09:55:42 AM »
it's not hard but for inside (in-cab) you'll probably need to take the dash off so you gain access to the harness, engine bay is quite easy
all of course with an original or new replacement harness.
'95 YJ, NSG370 6spd / Hurst shifter, Dana 300 + 4:1 Doubler / tri-stick, Custom skid, Super D35 / Auburn LSD / 4.88, 35x12.5x15 BFG KM2, 64mm t/b, 1.7 RollerRockers, MkVIII e-fan, Dual Diaph Booster
Latest: Corbeau BajaRS heated seats :dance: keeping warm the rear end