Author Topic: 4.56 or 4.88 gears  (Read 5904 times)

0 Members and 3 Guests are viewing this topic.

Offline grumpygy

  • Member
  • Posts: 882
Re: 4.56 or 4.88 gears
« Reply #15 on: December 06, 2011, 08:03:10 PM »
I must be lucky cause with 31.5 I can hit 80 on flat ground.  Now it does take me a while But I can.  since the Highest speed here in Oregon is 65 Most times I run 70.  Takes a steep hill to slow it down and most times I still do not need to down shift before I reach the top.  And I'm running stock 4.10.
94 YJ, Cool Air intake, 19lb Inj, 4.0 Throttlebody with spacer,  31/10.50/15's

Offline Jeffy

  • Administrator
  • Member
  • Posts: 14934
Re: 4.56 or 4.88 gears
« Reply #16 on: December 06, 2011, 11:22:27 PM »
I must be lucky cause with 31.5 I can hit 80 on flat ground.  Now it does take me a while But I can.  since the Highest speed here in Oregon is 65 Most times I run 70.  Takes a steep hill to slow it down and most times I still do not need to down shift before I reach the top.  And I'm running stock 4.10.
That's still pretty close to stock tires.   31's are rarely 31" tall.  Most AT's are well under.  Around 30.3-5".  MT's are usualyl 30.5-7".

If there's no wind and it's flat, I can probably get up to 80mph but it would take a long runup.  Once the gears kick in, I can usually hold 80 as long as I don't have to slow down.  Slow down and if there is a heavy wind and or small hills and I can't get back to 80.  Long run down hills is a lot easier but like I said, it gets sketchy with a tall Jeep.
Youtube Channel: https://www.youtube.com/channel/UCZNlr60GXH5OlKIFrT7P6mg
My Jeep: http://4bangerjp.com/forums/index.php?topic=2783.0
"If the motor car were invented today, there is absolutely no way that any government in the world would let normal members of the public drive one."

Torch_Ind

  • Guest
Re: 4.56 or 4.88 gears
« Reply #17 on: December 07, 2011, 03:50:57 PM »
I must be lucky cause with 31.5 I can hit 80 on flat ground.  Now it does take me a while But I can.  since the Highest speed here in Oregon is 65 Most times I run 70.  Takes a steep hill to slow it down and most times I still do not need to down shift before I reach the top.  And I'm running stock 4.10.

my jeep would be a rocket on 31's with 4.88's

Offline jfrabat

  • Gargantuan Mango Tree MechanicŪ
  • Member
  • *
  • Posts: 3676
  • Finally USING the Jeep!
Re: 4.56 or 4.88 gears
« Reply #18 on: December 07, 2011, 09:38:18 PM »
my jeep would be a rocket on 31's with 4.88's

When I ran that combo, I could hold 80mph on the FL turnpike no problem (5th gear with cruise control on holdingn the speed steady)
'94 YJ 2.5L with 4" RE lift, Superwinch EPi9.0, FoMoCo e-Fan, SD30 and SD35 w/ARB-5.13, 165A alt., 33" BFG KM2 on 15" AR wheels, Sony sound system, Pavement Ends Hardtop, Hydroboost

4banged

  • Guest
Re: 4.56 or 4.88 gears
« Reply #19 on: December 08, 2011, 07:00:14 AM »
When I ran that combo, I could hold 80mph on the FL turnpike no problem (5th gear with cruise control on holdingn the speed steady)

Wow, you guys don't know good you have it.  My 3rd gear is 1 to 1 then od is .69 ... Might as well shift it into reverse!  :wall:

Offline jfrabat

  • Gargantuan Mango Tree MechanicŪ
  • Member
  • *
  • Posts: 3676
  • Finally USING the Jeep!
Re: 4.56 or 4.88 gears
« Reply #20 on: December 08, 2011, 08:02:36 AM »
Wow, you guys don't know good you have it. 

Well, me being a Jeeper, I could not leave well enough alone, so I went to 33's and lost that..  Of course, i gained more offroadability, but I had to sacrifice this.
'94 YJ 2.5L with 4" RE lift, Superwinch EPi9.0, FoMoCo e-Fan, SD30 and SD35 w/ARB-5.13, 165A alt., 33" BFG KM2 on 15" AR wheels, Sony sound system, Pavement Ends Hardtop, Hydroboost

KenF

  • Guest
Re: 4.56 or 4.88 gears
« Reply #21 on: December 09, 2011, 08:15:07 AM »
I picked a D44 rear out of a rubicon to put my 95 YJ. It has 5.13s .
Need to decide what to do up front. Been told 5.13s an D30 is a bad idea. Pinion way too small (weak).
I plan on running 32" TSL radials.
Should I swap out the front axel and keep the 5.13s.
Our build up the D30 with4.88s and change to D44 to match ?

Offline neale_rs

  • Member
  • Posts: 3583
Re: 4.56 or 4.88 gears
« Reply #22 on: December 09, 2011, 08:49:33 AM »
With 32s, 4.88 should work very well.  But if you plan to go to 35's, a front D44 and 5.13s would be a great setup.
'95 YJ, 33 x 12.5 mud tires, RE 4.5 ED lift, Atlas 4 speed, rear D44, ARBs front and rear, 4.56 gears, 8000# winch

Offline sharpxmen

  • Chief Squirrel BlowerŪ
  • Member
  • *
  • Posts: 7093
Re: 4.56 or 4.88 gears
« Reply #23 on: December 09, 2011, 11:14:31 AM »
If there's no wind and it's flat, I can probably get up to 80mph but it would take a long runup.  Once the gears kick in, I can usually hold 80 as long as I don't have to slow down.  Slow down and if there is a heavy wind and or small hills and I can't get back to 80.  Long run down hills is a lot easier but like I said, it gets sketchy with a tall Jeep.

reading all these posts went for it this morning on the hwy, got up to 85mph and it seemed to be able to go more, had to let off as there was traffic ahead of me and also my tires are way out of balance, once i get over 110kph (65mph) you can really feel them so need to take care of that first. I want 35s but I am really concerned to lose whatever pep she's got now.

EDIT: not sure if there was wind or not but (didn't feel there was) but to be honest a realistic test would be to go both ways and average the result, even a 5 mph wind makes a difference with the wide/tall tires and jeep lifted 5 inches.
« Last Edit: December 09, 2011, 11:17:43 AM by sharpxmen »
'95 YJ, NSG370 6spd / Hurst shifter, Dana 300 + 4:1 Doubler / tri-stick, Custom skid, Super D35 / Auburn LSD / 4.88, 35x12.5x15 BFG KM2, 64mm t/b, 1.7 RollerRockers, MkVIII e-fan, Dual Diaph Booster
Latest: Corbeau BajaRS heated seats :dance: keeping warm the rear end

Offline chardrc

  • Member
  • Posts: 3535
Re: 4.56 or 4.88 gears
« Reply #24 on: December 09, 2011, 01:08:18 PM »
x2. after the 50mm tb swap my jeep  (4:10 31's tbi) can do 80 all day on the freeway if its fairly flat. it does hit a aerodynamic wall at about 88mph though.. but no need to go that fast in a jeep anyways. I wonder if some people aren't factoring in the amount the speedometer is off with bigger tires without changing the speedo gear.
1990 YJ 4cly, ax5, 2.5 inch BDS lift, 31 MTr\'s,  Powertrax-lockers all around, track-bars removed, boomerang shackles, warn m8000 winch, electric fan. [sold but not forgotten]

2007 jk Rubicon 2dr

Offline sharpxmen

  • Chief Squirrel BlowerŪ
  • Member
  • *
  • Posts: 7093
Re: 4.56 or 4.88 gears
« Reply #25 on: December 09, 2011, 02:41:23 PM »
I wonder if some people aren't factoring in the amount the speedometer is off with bigger tires without changing the speedo gear.

some people don't but it's been repeated here lots of times so eventually they figure it out.

did my gas mileage, first 200 km (120 mi) i got 18L/100km which is 13.1mpg, did it again today and got 16.34L/100km or 14.5mpg - I could probably get 15 but i doubt i can get any better than that, possibly in the summer since will get to temp quicker but not sure how much difference that would be (with 4.88 seems a bit better than with 4.10 as i was always in the 13mpg range before swapping the gears)
'95 YJ, NSG370 6spd / Hurst shifter, Dana 300 + 4:1 Doubler / tri-stick, Custom skid, Super D35 / Auburn LSD / 4.88, 35x12.5x15 BFG KM2, 64mm t/b, 1.7 RollerRockers, MkVIII e-fan, Dual Diaph Booster
Latest: Corbeau BajaRS heated seats :dance: keeping warm the rear end

Offline jfrabat

  • Gargantuan Mango Tree MechanicŪ
  • Member
  • *
  • Posts: 3676
  • Finally USING the Jeep!
Re: 4.56 or 4.88 gears
« Reply #26 on: December 09, 2011, 03:08:52 PM »
with 4.88 seems a bit better than with 4.10 as i was always in the 13mpg range before swapping the gears

When I swapped from 4.10 to 4.88, I also gained about 1 mpg...  But then I lost about 1.5 when I went from 31's to 33's!  :blbl:
'94 YJ 2.5L with 4" RE lift, Superwinch EPi9.0, FoMoCo e-Fan, SD30 and SD35 w/ARB-5.13, 165A alt., 33" BFG KM2 on 15" AR wheels, Sony sound system, Pavement Ends Hardtop, Hydroboost

Offline neale_rs

  • Member
  • Posts: 3583
Re: 4.56 or 4.88 gears
« Reply #27 on: December 09, 2011, 03:43:46 PM »

With the jumps between gears in a manual tranny it is hard to say what gearing in the diffs will be better.  For highway use, you might hit a sweet spot dead on with 4.56 diff gears in 4th gear and you might end up with neither 4th nor 5th being as good with 4.88 in the diffs.  To really optimize your setup, you would need to do some real world testing and some math.

'95 YJ, 33 x 12.5 mud tires, RE 4.5 ED lift, Atlas 4 speed, rear D44, ARBs front and rear, 4.56 gears, 8000# winch

Offline dwtaylorpdx

  • Member
  • Posts: 1038
Re: 4.56 or 4.88 gears
« Reply #28 on: December 10, 2011, 01:08:44 AM »
I used my GPS for getting the speed...  I never have trusted the speedometer on the jeep ... :)

dave
94 YJ - 2.5 Hesco Cam B&B Ported - AX5 Trans w/Centerforce Dual Friction Clutch - 4" Rough Country Lift W/Skyjacker Shocks - D44 Rear/ARB - D30/ARB - ARB Compressor - Warn M8000 in Custom Bumper - Reunell Rear Bumper - Metalcloak 6" Body Armor Kit - Tuffy Console - 265x85-16 Tires - 2M Radio