Author Topic: Running rough at low RPM and stalls  (Read 1458 times)

0 Members and 2 Guests are viewing this topic.

Offline stan98tj

  • Empty Wallet Wheeling Since 2007®
  • Member
  • *
  • Posts: 1816
  • Wheeling New England
Running rough at low RPM and stalls
« on: February 15, 2013, 03:41:47 PM »
Hey guys,
Jeep has been running odd recently. I notice it runs very rough at low rpms, requiring me to tap the gas to have it settle out, then as soon as I gas up and get out onto the road, it runs fine. I usually notice this as I'm pulling out of the parking garage at my union hall. When I start up in the morning, there is no issue, I drive down the road at low RPMs just fine, drive 86 miles and when I get to the parking garage, still no issue. However, when I leave  (usually about an hour or 2 later) the jeep runs rough as I'm driving out of the parking garage and settles as I get to the road. Today however, I stopped at my neighbors for a chat, left his place and headed down to my place (rpms about 1500) the jeep ran real rough and stalled as I turned into my driveway. This continued as I started up and nearly stalled in reverse as well were it not for a tap of the gas pedal. Doesn't seem to happen in park, however.

Jeep stats are 3spd auto, 98 TJ 4cyl. Air filter recently cleaned, fuel injectors cleaned about 3 yrs ago.
98 TJ 35"Maxxis Trep.Old Man Emu 2.5""+1"BL,IronMan Fab control arms,4.56gears,Ford 8.8+ARB,Currie/IronMan steering, WARN VR10,HP D30 sleeved+ RCV,Body Armor Rock Rails WISHLIST:TDi.Girlfriend hates it :) If you can read this don't flip me over i dont have any $$ left to fix it

Offline sharpxmen

  • Chief Squirrel Blower®
  • Member
  • *
  • Posts: 7093
Re: Running rough at low RPM and stalls
« Reply #1 on: February 15, 2013, 04:39:25 PM »
there could be a bunch of things but the more obvious would be that one of the cylinders is not running right at low rpm, that can be due to an ignition problem (plugs, wires, cap, rotor), a bad injector that squirts or a bad tps (this happened to me). I'm sure there can be other reasons but this is just what i'm guessing - might help if when it starts doing it you pull over and pull the plugs out and see how they look (wet or color differences between them). does it run rough at idle also? any codes?
'95 YJ, NSG370 6spd / Hurst shifter, Dana 300 + 4:1 Doubler / tri-stick, Custom skid, Super D35 / Auburn LSD / 4.88, 35x12.5x15 BFG KM2, 64mm t/b, 1.7 RollerRockers, MkVIII e-fan, Dual Diaph Booster
Latest: Corbeau BajaRS heated seats :dance: keeping warm the rear end

Offline stan98tj

  • Empty Wallet Wheeling Since 2007®
  • Member
  • *
  • Posts: 1816
  • Wheeling New England
Re: Running rough at low RPM and stalls
« Reply #2 on: February 15, 2013, 05:02:59 PM »
there could be a bunch of things but the more obvious would be that one of the cylinders is not running right at low rpm, that can be due to an ignition problem (plugs, wires, cap, rotor), a bad injector that squirts or a bad tps (this happened to me). I'm sure there can be other reasons but this is just what i'm guessing - might help if when it starts doing it you pull over and pull the plugs out and see how they look (wet or color differences between them). does it run rough at idle also? any codes?
No codes and every now and again runs rough at idle, although recently has been fine at idle.
98 TJ 35"Maxxis Trep.Old Man Emu 2.5""+1"BL,IronMan Fab control arms,4.56gears,Ford 8.8+ARB,Currie/IronMan steering, WARN VR10,HP D30 sleeved+ RCV,Body Armor Rock Rails WISHLIST:TDi.Girlfriend hates it :) If you can read this don't flip me over i dont have any $$ left to fix it

Offline stan98tj

  • Empty Wallet Wheeling Since 2007®
  • Member
  • *
  • Posts: 1816
  • Wheeling New England
Re: Running rough at low RPM and stalls
« Reply #3 on: February 15, 2013, 05:03:49 PM »
the spark plugs are old, and another friend suggested that as well. I guess I'll change them and see what happens.
98 TJ 35"Maxxis Trep.Old Man Emu 2.5""+1"BL,IronMan Fab control arms,4.56gears,Ford 8.8+ARB,Currie/IronMan steering, WARN VR10,HP D30 sleeved+ RCV,Body Armor Rock Rails WISHLIST:TDi.Girlfriend hates it :) If you can read this don't flip me over i dont have any $$ left to fix it

Offline aw12345

  • Member
  • Posts: 3065
    • my jeep picture page
Re: Running rough at low RPM and stalls
« Reply #4 on: February 15, 2013, 06:26:34 PM »
Check ignition parts if that is fine, start looking for a leaking fuel injector
2006 Jeep Wrangler TJ SE
2004 Jeep Wrangler TJ SE

Offline sharpxmen

  • Chief Squirrel Blower®
  • Member
  • *
  • Posts: 7093
Re: Running rough at low RPM and stalls
« Reply #5 on: February 15, 2013, 08:59:18 PM »
the other thing that happened to 2 of the members here (if i remember correctly) is to check the injector connectors, apparently it happens that they don't make good contact and due to vibrations going in/out of service (not opening due to poor electical contact) and creating the rough then good then back to rough running sequence.
'95 YJ, NSG370 6spd / Hurst shifter, Dana 300 + 4:1 Doubler / tri-stick, Custom skid, Super D35 / Auburn LSD / 4.88, 35x12.5x15 BFG KM2, 64mm t/b, 1.7 RollerRockers, MkVIII e-fan, Dual Diaph Booster
Latest: Corbeau BajaRS heated seats :dance: keeping warm the rear end

Offline stan98tj

  • Empty Wallet Wheeling Since 2007®
  • Member
  • *
  • Posts: 1816
  • Wheeling New England
Re: Running rough at low RPM and stalls
« Reply #6 on: February 23, 2013, 04:22:17 PM »
I checked the IAC and TPS, made sure they were clean and then changed my plugs. Hasn't acted up since. The plugs were kinda worn.
98 TJ 35"Maxxis Trep.Old Man Emu 2.5""+1"BL,IronMan Fab control arms,4.56gears,Ford 8.8+ARB,Currie/IronMan steering, WARN VR10,HP D30 sleeved+ RCV,Body Armor Rock Rails WISHLIST:TDi.Girlfriend hates it :) If you can read this don't flip me over i dont have any $$ left to fix it