My jeep is a 91 with the half cage not the full like the 92-95. The top uses the soft top hardware for the front half like normal to make the door frames and then the rear arms and tension bars just push all the way forward against the back of the door frames.
This is the best side profile one I have at the moment, I will take some better ones tomorrow when its light out
The rear tonneau part pulled decently tight when it was new but after being outside and heating and cooling with the weather it has stretched some and with the snow and rain sitting on it has also helped stretch it. I took some fiberglass rods that are about an inch wide and maybe an 1/8th in thick, from some of the temporary men working signs i had that you use to hold the sign open and drilled the rivet out and spread it across the back area to keep the top arched up so the water ran off instead of pooling in the center
