« previous next »
Pages: 1 [2]   Go Down

Author Topic: Trannie leak  (Read 2753 times)

0 Members and 5 Guests are viewing this topic.

Offline Bounty Hunter

  • Member
  • Posts: 1658
    • http://www.sija.org
Re: Trannie leak
« Reply #15 on: August 19, 2010, 08:11:24 PM »
You can do it, and don't worry about the questions, no question is too dumb.  Place a screwdriver or small prybar behind the flat bar section of linkage and work it off the transfer case.  Once the nut is off, it's only a slip fit onto the shaft.
Logged

tracker975

  • Guest
Re: Trannie leak
« Reply #16 on: August 19, 2010, 08:17:56 PM »
OK....gotcha...Thanks again Joey
Logged

Offline Jeffy

  • Administrator
  • Member
  • Posts: 14934
Re: Trannie leak
« Reply #17 on: August 19, 2010, 08:41:07 PM »
Just consider a better topic name...  Trannie isn't what you might think it means.  :whistle:
Logged
Youtube Channel: https://www.youtube.com/channel/UCZNlr60GXH5OlKIFrT7P6mg
My Jeep: http://4bangerjp.com/forums/index.php?topic=2783.0
"If the motor car were invented today, there is absolutely no way that any government in the world would let normal members of the public drive one."

tracker975

  • Guest
Re: Trannie leak
« Reply #18 on: August 19, 2010, 08:50:48 PM »
LOL..your right....but at least I was close...it is leaking trannie fluid....
Logged

tracker975

  • Guest
Re: Trannie leak
« Reply #19 on: August 21, 2010, 12:06:08 PM »
Well...I got the old seal out and the new one in....I just hope I didn't booger the new seal putting the T/C case back in :yikes:....on my back...by myself...with a seperated shoulder and a broken finger lol....had to do a bit of wiggling..not much but it took a few wiggles to get it lined up..then it just slid right in...the old seal was hard as a brick and fell apart when I took it out lol.....I'll let ya know later..........Thanks Joey
Logged

Offline sharpxmen

  • Chief Squirrel BlowerŪ
  • Member
  • *
  • Posts: 7093
Re: Trannie leak
« Reply #20 on: August 21, 2010, 06:49:53 PM »
Quote from: tracker975 on August 19, 2010, 08:50:48 PM
LOL..your right....but at least I was close...it is leaking trannie fluid....

jeffy meant it's tranny and not trannie
Logged
'95 YJ, NSG370 6spd / Hurst shifter, Dana 300 + 4:1 Doubler / tri-stick, Custom skid, Super D35 / Auburn LSD / 4.88, 35x12.5x15 BFG KM2, 64mm t/b, 1.7 RollerRockers, MkVIII e-fan, Dual Diaph Booster
Latest: Corbeau BajaRS heated seats :dance: keeping warm the rear end

tracker975

  • Guest
Re: Trannie leak
« Reply #21 on: August 21, 2010, 07:27:56 PM »
LOLOLOLOLOLOLOL.........holy crap  :yikes:I can't stop laughing...I just got it....I will be more careful in the future..crap thats funny...Joey
Logged

Offline Jeffy

  • Administrator
  • Member
  • Posts: 14934
Re: Trannie leak
« Reply #22 on: August 21, 2010, 07:42:22 PM »
Quote from: sharpxmen on August 21, 2010, 06:49:53 PM
jeffy meant it's tranny and not trannie
Personally, I'd rather call it a Trans or Transmission...
Logged
Youtube Channel: https://www.youtube.com/channel/UCZNlr60GXH5OlKIFrT7P6mg
My Jeep: http://4bangerjp.com/forums/index.php?topic=2783.0
"If the motor car were invented today, there is absolutely no way that any government in the world would let normal members of the public drive one."

tracker975

  • Guest
Re: Trannie leak
« Reply #23 on: August 21, 2010, 08:08:17 PM »
Make no mistake about it I will definitely change my nomenclature lol....Trans it is...Joey
Logged

Offline Jeffy

  • Administrator
  • Member
  • Posts: 14934
Re: Trannie leak
« Reply #24 on: August 21, 2010, 09:46:31 PM »
Quote from: tracker975 on August 21, 2010, 08:08:17 PM
Make no mistake about it I will definitely change my nomenclature lol....Trans it is...Joey
Yeah, 'Trannie leak' sounds pretty bad...
Logged
Youtube Channel: https://www.youtube.com/channel/UCZNlr60GXH5OlKIFrT7P6mg
My Jeep: http://4bangerjp.com/forums/index.php?topic=2783.0
"If the motor car were invented today, there is absolutely no way that any government in the world would let normal members of the public drive one."

Offline sharpxmen

  • Chief Squirrel BlowerŪ
  • Member
  • *
  • Posts: 7093
Re: Trannie leak
« Reply #25 on: August 21, 2010, 10:14:06 PM »
Quote from: Jeffy on August 21, 2010, 09:46:31 PM
Yeah, 'Trannie leak' sounds pretty bad...

probably increased the hits on the website :lol:
Logged
'95 YJ, NSG370 6spd / Hurst shifter, Dana 300 + 4:1 Doubler / tri-stick, Custom skid, Super D35 / Auburn LSD / 4.88, 35x12.5x15 BFG KM2, 64mm t/b, 1.7 RollerRockers, MkVIII e-fan, Dual Diaph Booster
Latest: Corbeau BajaRS heated seats :dance: keeping warm the rear end
Pages: 1 [2]   Go Up
« previous next »