Topic: anyone running a M.O.R.E 1" body lift

[01amberfirewv]

I just picked up a used one.  Seems like quality stuff with all metal hardware.  How do you like yours?  How hard was the install?  Do you have any pics?

I plan on adding a MML after I get the BL installed.  What is the best one for a 2.5?

[Jeffy]

I was going to get a MORE set but decided against it when the JKS/Currie were on sale. :roll:

[jagular7]

I have someone's which I don't recall whose. But here is a couple of suggestions:
- there are 2 body mounts above the rear axle, don't forget about those.
- while the body is off the frame, add the front grille spacer as there is room for your hands then.

[shotgun]

Most people around my neck of the woods have a poly 1" bodylift.  Since it's replacing the whole body bushing.

[SMC4WD]

I'm running a Daystar 1" bushing kit, with a 1" MML by the same company.  We had to do some custom modificatons to the 4.0L MML to make it work on a 2.5L.  I had wished that I used the MORE MML instead of Daystar only because it's rubber instead of the polyuthane bushings.

This didn't answer your question, it's just input.

MORE does a fantastic job, and you should be very satisfied.