« previous next »
Pages: [1]   Go Down

Author Topic: Caster YJ's Dana30  (Read 1801 times)

0 Members and 1 Guest are viewing this topic.

Tappie

  • Guest
Caster YJ's Dana30
« on: August 25, 2005, 03:21:58 PM »
Hi,

I'm busy putting my YJ on SOA. The rear axle is in place, and now i'm working on the front axle. I found out that the axle has to sit back 6-8 degrees (stock). Can anyone tell me if I put the diff yoke horizontally, will the caster be around 7 degrees? (is caster allready in the axle?). Or do i need to put the yoke in a certain angle? I can't mesure it in the stock setup and copy it, don't have the stock leaves anymore....  :?

Thanks,
Charon
Logged

Offline Jeffy

  • Administrator
  • Member
  • Posts: 14934
Caster YJ's Dana30
« Reply #1 on: August 25, 2005, 09:40:57 PM »
I'd just make the new perches parallel to the old ones.  Makes it easy.
Logged
Youtube Channel: https://www.youtube.com/channel/UCZNlr60GXH5OlKIFrT7P6mg
My Jeep: http://4bangerjp.com/forums/index.php?topic=2783.0
"If the motor car were invented today, there is absolutely no way that any government in the world would let normal members of the public drive one."

ratherbejeeping

  • Guest
Caster YJ's Dana30
« Reply #2 on: August 26, 2005, 09:08:15 AM »
Quote from: "Jeffy"
I'd just make the new perches parallel to the old ones.  Makes it easy.


What he said.  I've done a bunch of these and never had an issue.
Logged

shotgun

  • Guest
Caster YJ's Dana30
« Reply #3 on: August 26, 2005, 01:50:41 PM »
you left the stock perches on there? I reused mine. we put a magnetic angle finder on the steering knuckle to find the angle. Somewhere near the ball joint we found a flat enough spot.
Logged
Pages: [1]   Go Up
« previous next »